Line Source is the connector with a male contact which is normally connected to the source of the power. The contacts are fitted with a plastic end cap that prevents accidental finger touching of live parts of the connector and meets IP2X requirements. Different contacts are available to suit cable conductors from 25 mm2 to 300 mm2.
Connectors rated either 400 amp or 660 amp, can be fitted to a wide range of copper
cables, and to aluminium cables on request.
The 400 amp connectors use a standard set-screw contact suitable for 120mm2
conductors; when using smaller conductors a range of reduction sleeves are available to order separately that can be used with cables down to 25mm2, see page M-2 for further information.
660 amp contacts are crimped using industry standard crimping tools and dies, a range of contacts are available to suit cables from 35mm2 to 300mm2
Cable glands meeting IP67 requirements are fitted to the connectors, 4 sizes are available that cover a range of cables with outside diameters from 15mm to 38mm. When selecting the M50 gland,please note that this is supplied with an adaptor (not shown above) that steps the connector up from M40 to M50.
|
| Connector Style |
Line Source |
| Mounting Type |
Line |
| No of Contacts |
1 |
| Contact Style |
Pin |
| Contacts Supplied |
Y |
| Shell Material |
Thermoplastic |
| Shell Color |
Red |
| Amperage Rating |
660 amp |
| Operating Temperature °F (°C) |
-30C to +125C (-22F to +257F) |
| RoHS |
Yes |
