MW-Series panel-mount receptacles are available with 4,9, or 18 contacts in QPL and filtered configurations. Filtered receptacles utilize planar capacitors to enable high-density designs that survive the shock and vibration of repeated field deployments.

• QPL certified: M55181/2-01, M55181/4-01, M55181/6-01, andM55181/8-01.
• Cadmium plated, brass shells with olive-drab chromate; stainless steel draw screws.
• Accessories include dust caps and backshells.
• Filtered solutions can be optimized for application-specific voltage, frequency, and impedance requirements.

Rugged plug designs feature aluminum-alloy bodies with heat-treated-steel nosepieces. Finish options include cadmium with olive-drab chromate plating and RoHS compliant, electroless nickel with black-trivalent chromate.

• QPL certified: M55181/1, M55181/3, M55181/5, and M55181/7 QPL configurations available with -01 through -05 cable size designators.
• Copper-alloy sockets and yellow-brass pins feature gold over nickel contact platings.
• Voltage drops for mated four-contact connectors less than 20mV at 35 amps; 9 and 18 contact models less than 25mV at 7.5 amps.

These MIL-DTL-55181 compatible connectors incorporate a straight-backshell design that is suitable for in-line and panel-mount military applications. Plugs and receptacles are available in 4, 9, or 18 pin or socket configurations.

• Shielded ferrules simplify cable-to-shield terminations.
• Finish options include cadmium, nickel, and RoHS compliant black nickel.
• Termination options include turrets and solder cups.
• Compatible with all cable sizes defined by MIL-DTL-55181 -01 to -05 cable diameter designators.

The stacking connector enables power splitting without the use of Y cables by incorporating plug contacts on the front mating surface and receptacle contacts on the rear mating surface.

The stacking connector plug contacts are mated to the battery pictured to the left. Internal contacts provide electrical continuity between the plug contacts, attached cable, and receptacle contacts that are mated to the QPL connector stacked on top of it.

• When used without a "piggybacked" connector mated to the receptacle contacts, the stacking connector functions identical to a MIL-DTL-55181 plug.
• The stacking connector can be ordered with factory installed cables or customers can install cables in the same manner as any QPL connector.

Dual-entry connectors incorporate a single-plug body that distributes power to two cables. These MIL-DTL-55181 compliant solutions are available in 4, 9, or 18-contact configurations.

• Sealed aluminum housings with cadmium/olive-drab chromate or RoHS compliant platings.
• Available with 75 and 90 degree cable-entry configurations.
• Facilitates lower cost power-splitting solutions than traditional Y cables.
• Rugged designs are rated for 500 mate and demate cycles.
• Custom capabilities include wiring harnesses and cable assemblies.